Important: Use care when handling the mass air flow (MAF)/intake air temperature (IAT) sensor. Do not dent, puncture, or otherwise damage the honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation.

1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
2. Disconnect the engine wiring harness electrical connector (1) from the MAF/IAT sensor.



3. Loosen the MAF/IAT sensor seal clamp (1).
4. Remove the MAF/IAT sensor from the air cleaner assembly.

Important: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.

1. Install the MAF/IAT sensor to the air cleaner assembly.

Notice: Refer to Fastener Notice in the Preface section.

2. Tighten the MAF/IAT sensor seal clamp.

Tighten
Tighten the clamp to 4 N·m (35 lb in).




3. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .