Important: Clean all the fuel pipe connections and surrounding areas before disconnecting the pipe in order to avoid possible fuel system contamination.

1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
2. Disconnect the chassis fuel feed pipe (1) from the engine compartment feed pipe. Refer to Metal Collar Quick Connect Fitting Service .
3. Cap the fuel pipes in order to prevent possible fuel system contamination.



4. Remove the fuel pipe retainer nuts (1).
5. Remove the fuel pipe bracket bolt (2).



6. Remove the fuel pipe retainer.
7. Pull straight up on the pipe in order to remove the pipe from the fuel meter body.



8. Remove and discard the following components from the fuel meter body:

•	Fuel seal retainer (1)

•	Upper fuel seal (2)

•	Spacer ring (3)

•	Lower fuel seal (4)

1. Install the following NEW components to the fuel meter body:

•	Lower fuel seal (4)

•	Spacer ring (3)

•	Upper fuel seal (2)

•	Fuel seal retainer (1)





Caution: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

2. Apply a few drops of clean engine oil to the fuel pipe end.
3. Install the fuel pipe to the fuel meter body.
4. Install the fuel pipe retainer.

Notice: Refer to Fastener Notice in the Preface section.




5. Install the fuel pipe bracket bolt (2).

Tighten
Tighten the bolt to 6 N·m (53 lb in).

6. Install the fuel pipe retainer nuts (1).

Tighten
Tighten the nuts to 3 N·m (27 lb in).




7. Remove the caps from the fuel pipes.
8. Connect the chassis fuel feed pipe (1) to the engine compartment feed pipe. Refer to Metal Collar Quick Connect Fitting Service .
9. Test the system for leaks using the following procedure:

9.1.	Turn the ignition ON, with the engine OFF for 2 seconds.

9.2.	Turn the ignition OFF for 10 seconds.

9.3.	Turn the ignition ON, with the engine OFF.

9.4.	Inspect for fuel leaks.