Tools Required

J 44643 Flywheel Holding Tool

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the right wheelhouse panel. Refer to Front Wheelhouse Liner Replacement - Right Side .
3. Remove the starter motor bolts. Reposition the starter aside. The wiring to the starter does not require removal.



4. Install J 44643 in order to hold the flywheel.
5. Remove the lower fan shroud. Refer to Engine Coolant Fan Lower Shroud Replacement .



6. Remove the crankshaft balancer bolt.
7. Remove the crankshaft balancer.
8. If required, clean and inspect the crankshaft balancer. Refer to Crankshaft Balancer Cleaning and Inspection .

1. Lubricate the crankshaft balancer internal hub with clean engine oil.
2. Install the crankshaft balancer on the crankshaft.
3. Lubricate the crankshaft balancer bolt with clean engine oil.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the crankshaft balancer bolt and washer.

Tighten
Tighten the bolt to 353 N·m (260 lb ft).




5. Remove J 44643 .



6. Position the starter motor.
7. Install the starter motor bolts.

Tighten
Tighten the bolts to 78 N·m (58 lb ft).

8. Install the right wheelhouse panel. Refer to Front Wheelhouse Liner Replacement - Right Side .
9. Install the lower fan shroud. Refer to Engine Coolant Fan Lower Shroud Replacement .
10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .