Callout
| Component Name
|
Preliminary Procedure
| • | Using the
J 7079-2
, remove the bearings from the front case half. |
| • | Ensure the bearings are installed squarely into the bearing bores. |
|
1
| Transfer Case Shift Detent Lever Bearing - Inner
Tip
| • | Ensure the printing on the bearing is facing upward. |
| • | Install the bearing using the long side of the
DT-48215
. |
| • | Press the bearing until the tool bottoms on the front case half. |
Special Tools
| • | DT-48215
Shift Detent Lever Bearing Installer |
| • | J 7079-2
Universal Driver Handle - Non-Threaded |
|
2
| Transfer Case Shift Detent Lever Bearing - Outer
Tip
| • | Ensure the printing on the bearing is facing upward. |
| • | Install the bearing using the short side of the
DT-48215
. |
| • | Press the bearing until the tool bottoms on the front case half. |
Special Tools
| • | DT-48215
Shift Detent Lever Bearing Installer |
| • | J 7079-2
Universal Driver Handle - Non-Threaded |
|
