GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Sierra Classic - 2WD 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Instrument Cluster Replacement

Removal Procedure
  1. Remove the instrument panel cluster (IPC) trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .

    2. Object Number: 348794 Size: SH
  2. Remove the screws that retain the IPC to the instrument panel (I/P) assembly.

    3. Object Number: 854865 Size: SH
  3. Remove the IPC (2) from the vehicle by tilting the bottom of the cluster outward.
  4. Disconnect the IPC harness (1) from the IPC.

Installation Procedure

    Object Number: 854865 Size: SH
  1. Connect the IPC harness (1) to the IPC (2).

    2. Object Number: 348794 Size: SH
  2. Install the IPC onto the I/P with the screws. Tilt the top of the cluster into the retainer first to avoid damaging the flexible circuit connections.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the screws that retain the IPC to the I/P assembly.

    4. Tighten
    Tighten the screws to 1.6 N·m (14 lb in).

  4. Install the IPC trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement.

    5. When the IPC is replaced the new IPC will need to be programmed. Refer to Control Module References for programming and setup information.