GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .

  2. Object Number: 755486  Size: SH
  3. Remove the shroud retaining screws from the back of the steering wheel.
  4. Remove the shroud from the steering wheel.

  5. Object Number: 755485  Size: SH
  6. Position a blunt-ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.

  7. Object Number: 652807  Size: SH
  8. Disconnect the steering wheel control switch electrical connector.
  9. Important: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.

  10. Remove the steering wheel control switch from the steering wheel.

Installation Procedure


    Object Number: 652807  Size: SH
  1. Position the steering wheel control switch to the steering wheel.
  2. Connect the electrical connector to the steering wheel control switch.
  3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.

  4. Object Number: 755486  Size: SH
  5. Install the shroud to the steering wheel.
  6. Notice: Refer to Fastener Notice in the Preface section.

  7. Install the shroud retaining screws to the steering wheel.
  8. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  9. Install the steering wheel. Refer to Steering Wheel Replacement .