GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Instrument Cluster Schematics

Connector End View Reference: Displays and Gages Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Turn ON the ignition, with the engine OFF.
  2. Install a scan tool.
  3. With the scan tool, perform the segments test in the instrument panel cluster (IPC) scan tool output controls.

Do all of the segments of the driver information center (DIC) illuminate?

Go to Step 3

Go to Step 6

3

  1. Install a scan tool.
  2. Raise the vehicle drive wheels. Refer to Lifting and Jacking the Vehicle .
  3. Start the engine.
  4. Place the transmission into drive for automatic transmission or third gear for manual transmission.
  5. With the scan tool, observe the Vehicle Speed Sensor (VSS) parameter in the IPC Data 1 data list.

Does the VSS parameter match the speedometer display?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 4

4

Test the vehicle speed signal circuit for a high resistance between the IPC and the powertrain control module (PCM). Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 7

Go to Step 5

5

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 7

Go to Step 6

6

Replace the IPC. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 7

--

7

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3