Important: If both of the door striker bolts are removed at the same time, the striker backing plate will fall into the body. This will result in additional time to perform the repair.

1. Remove the lower striker bolt.
2. Loosen the upper striker bolt enough in order to rotate the striker and the spacer (if equipped) away from the lower bolt hole.
3. Install the lower striker bolt. Tighten the lower striker bolt sufficiently in order to hold the striker backing plate in place.
4. Remove the upper striker bolt.
5. Remove the spacer, if equipped.
6. Remove the striker.

1. Install the striker.
2. Install the spacer, if equipped.
3. Install the upper striker bolt.
4. If the striker backing plate has moved, rotate the lower striker bolt until the upper threaded hole is properly aligned.
5. Remove the lower bolt.
6. Rotate the striker and the spacer, (if equipped) in order to align the lower threaded hole in the striker backing plate.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Tighten the striker bolts.

Tighten
Tighten the door striker bolts to 24 N·m (18 lb ft).