Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the transmission oil pan and filter. Refer to
Automatic Transmission Fluid and Filter Replacement.
- Remove the rear servo assembly from the transmission case as follows:
| • | Bottom retaining clip (3) |
| • | Outer ring oil seal (1) |
| • | Inner ring oil seal (7) |
| • | Servo spring retainer (12) |
| • | Accumulator spring (14) |
Installation Procedure
- Install the rear servo assembly to the transmission case as follows:
| • | Accumulator spring (14) |
| • | Servo spring retainer (12) |
| • | Inner ring oil seal (7) |
| • | Outer ring oil seal (1) |
| • | Bottom retaining clip (3) |
Caution: Refer to Fastener Caution in the Preface section.
- Install the cover bolts (61) and tighten to
24 N·m (18 lb ft).
- Install the transmission oil pan and filter. Refer to
Automatic Transmission Fluid and Filter Replacement.
- Lower the vehicle.
- Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to
Transmission Fluid Check.
Note: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
- Reset the TAP values. Refer to
Transmission Adaptive Functions.
