Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and suitable support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the outer tie rod to steering knuckle retaining nut.



4. Disconnect the outer tie rod from the steering knuckle using the J 24319-B .



5. Loosen the jam nut (2) and remove the outer tie rod (1) from the inner tie rod (3).
6. Inspect the shaft for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle.

1. Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer tie rod (1).
2. Install the outer tie rod (1) to the inner tie rod (3). Do not tighten jam nut at this time.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the outer tie rod to steering knuckle retaining nut and tighten to 63 N·m (47 lb ft).
4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
5. Lower the vehicle.
6. Adjust the front toe. Refer to Wheel Alignment Measurement.