Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the outer tie rod stud retaining nut.



4. Loosen the jam nut (2) on the inner tie rod (1).



5. Disconnect the outer tie rod from the steering knuckle using J 24319-B .



6. Remove the outer tie rod (3) from the inner tie rod (1).

1. Connect the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).

Caution: Refer to Fastener Caution in the Preface section.




2. Connect the outer tie rod to the steering knuckle.
3. Install the outer tie rod retaining nut and tighten to 63 N·m (47 lb ft).

Note: Be sure the power steering gear boot is not twisted after the toe adjustment.

4. Check the wheel alignment. Refer to Wheel Alignment Measurement.