1. Disconnect the quick release latch plates (2) for the lap-shoulder belts on the seat to be removed by pressing the tip of a key into the release hole of the safety belt buckle (1) while pulling up on the belt.

Important: On a three passenger seat there are two pins located on the inboard sides of the rear seats. On a four passenger seat, each half of the seat has a set of pins.

2. Locate the pins.



3. The driver's side pin (1) has a gray cap with a black "L" marked on it.



4. The passenger's side pin (1) has a black cap with a white "R" marked on it.
5. Pull the pin handle up to disengage the pin from the retaining clip, then pull the pin out.
6. Repeat this procedure for the other pin(s).
7. Pull the seat rearward about 2 inches (5 cm) and then lift the seat from the floor rails.
8. Remove the seat from the vehicle.



9. For the first row rear seat, stow the safety belt latch by attaching the clip (1) on the safety belt latch to the strip just inside the side door.
10. For the remaining rear seats, stow the safety belt latch plate on the clip at the window trim.

Caution: A seat that is not locked into place properly can move around in a collision or sudden stop. People in the vehicle could be injured. Be sure to lock the seat into place properly when installing it.

Caution: A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted.

1. Position the seat into the open slots in both rails. Push the seat forward in the rail, hooking both seat bases onto the pins inside of the rails.

Important: On a three passenger seat there are two pins located on the inboard sides of the rear seats. On a four passenger seat, each half of the seat has a set of pins.

2. To install the locking pins at the rear of the seat base, locate the hole in the rail for the pin. If the vehicle has floor mats, pull the flap that has been cut into the mat.
3. Insert the locking pins into the seat base and push the seat to line up the pins with the base.



4. Push the pin(s) (1) marked "R" down until they are in the retaining clip.



5. Push the pin(s) (1) marked "L" down until they are in the retaining clip.
6. If the vehicle has a floor mat, put the flap back to its original position.
7. Repeat this procedure for the other seat base, if equipped.
8. Connect the quick-release latch plates for the lap-shoulder belts by inserting the latch plates into the buckles attached at the outboard positions of the bench seat. Do not twist the belt.
9. Check that all the locking pins are locked into place before operating the vehicle.