Special Tools

J 39400-A Halogen Leak Detector

1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
2. Remove the coolant reservoir. Refer to Coolant Recovery Reservoir Replacement .



3. Disconnect the electrical connector (2) from A/C low pressure sensor (1).
4. Remove the evaporator outlet pipe retaining nut (3) from the accumulator.



5. Remove the compressor suction hose retaining nut (1).
6. Remove the compressor suction hose from the accumulator.



7. Remove the retaining screw (4) from the accumulator retaining bracket (2).
8. Remove the accumulator (1).
9. Remove the sealing washers.

1. If replacing the accumulator, add the specified amount of PAG oil directly into the accumulator. Refer to Refrigerant System Capacities .



2. Install the accumulator (1).

Notice: Refer to Fastener Notice in the Preface section.

3. Install the screw (4) to the accumulator retaining bracket (2).

Tighten
Tighten the screw to 9 N·m (80 lb in).




4. Connect the low pressure sensor electrical connector (1).



5. Install new sealing washers. Refer to Sealing Washer Replacement .
6. Install the evaporator outlet pipe.
7. Install the evaporator outlet pipe retaining nut (1) to the accumulator.

Tighten
Tighten the nut to 16 N·m (12 lb ft).

8. Install the compressor suction hose.
9. Install the compressor suction hose retaining nut (2) to the accumulator.

Tighten
Tighten the nut to 16 N·m (12 lb ft).

10. Install the coolant reservoir. Refer to Coolant Recovery Reservoir Replacement .
11. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
12. Leak test the fittings of the component using the J 39400-A .