Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1425 : Device 1 Voltage HighDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | B1424 | B1424 | -- | -- |
Ground | -- | B1424 | -- | -- |
Circuit/System Description
The Heater Coolant Heater Control Module (HCHCM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components, and incorrect data may occur when the voltage is out of range.
Conditions for Running the DTC
| • | The voltages supplied to the control module is between 9.5-18 V. |
| • | The ignition is ON. |
| • | The engine is running. |
Conditions for Setting the DTC
HCHCM detects a system voltage below 16 V for 5 seconds.
Action Taken When the DTC Sets
The control module immediately disables all outputs when an out of range voltage condition has been detected.
Conditions for Clearing the DTC
The DTC clears when the system voltage returns to a normal range.
Diagnostic Aids
| • | A possible cause of this DTC could be overcharging with a battery charger or jump starting. |
| • | A high voltage value in multiple modules indicates a concern in the charging system. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Air Temperature Description and Operation
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Observe the scan tool Auxiliary Heater Control Module, System Voltage High, System Voltage Low, DTC Set This Ignition parameters will assist you to verify if the fault is present.
- Verify that DTC B1425 is set as current.
- Engine running measure and record the voltage at the battery terminals.
- Verify that the battery voltage is 12.6-15.5 V.
- Observe the scan tool Auxiliary Heater Control Module ignition signal parameter.
- The battery terminal and AHCM parameter should not differ by more than 2 V.
| ⇒ | If the battery voltage is not within the specified range, refer to Charging System Test |
| ⇒ | If greater than specified value, replace the Heater Coolant Heater Control Module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
