Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Ignition | 1 | 1 | 1 | -- |
Backup Lamp Control | 1 | 1 | 1 | -- |
Ground | -- | 1 | -- | -- |
1. Inside Electrochromic Mirror Inoperative | ||||
Circuit/System Description
The automatic day-night rear view mirror uses 2 photocell sensors that detect an increase in light. One sensor is located in the rear side of the mirror. This sensor determines the light condition present at the mirror face. The other sensor is the ambient light sensor, located on the front of the mirror or windshield side. This sensor determines the amount of light present at the mirror. When the ambient light sensor senses a low light condition and a high light condition from behind at the headlight sensor, the inside rearview mirror will automatically darken the face of the mirror.
Reference Information
Schematic Reference
Outside Rearview Mirror Schematics
Connector End View Reference
Description and Operation
Automatic Day-Night Mirror Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, headlamps ON, vehicle in PARK, cover the front light sensor with a towel or other suitable item. Shine a flashlight at the rear light sensor while observing the inside rearview mirror face. The inside rearview mirror face should dim.
- Park brake applied, place the transmission in REVERSE. The inside rearview mirror face should transition from dim to bright.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the inside rearview mirror.
- Verify that a test lamp illuminates between B+ and the ground circuit terminal 8.
- Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 13 and ground.
- Ignition ON, park brake applied, vehicle in REVERSE, verify that a test lamp illuminates between the backup lamp control circuit terminal 9 and ground.
- If all circuits test normal, test or replace the inside rearview mirror.
| ⇒ | If the test lamp does not illuminate, test the ground circuit for an open/high resistance. |
| ⇒ | If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. |
| ⇒ | If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, refer to Backup Lamps Malfunction. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
