GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2004 🢒 Savana 🢒 Engine 🢒 Engine Mechanical - 4.8L, 5.3L, and 6.0L 🢒 Cylinder Head Assemble

Tools Required

J 8062 Valve Spring Compressor - Head Off


    Object Number: 1272854 Size: MH
  1. Clean the cylinder head valve spring shim area.

    2. Important: When using the valves and related components again, install the parts to their original location.

  2. Install the valves (227 and 228) into the proper port. Refer to Separating Parts .

    3. Important: The valve stem oil seal alignment and position on the valve guide is critical.

    An improperly installed valve stem oil seal may lead to excessive oil consumption, increased vehicle emissions, or component damage.

  3. Install the valve stem oil seal (222).
  4. Install the valve spring (223).
  5. Install the valve spring cap (224).

    6. Object Number: 260151 Size: SH
  6. Compress the valve spring using the J 8062 .
  7. Install the valve stem keys.
    8. 7.1. Use grease to hold the keys in place and remove the J 8062 .
    7.2. Ensure the keys seat properly in the groove of the valve stem.
    7.3. Tap the end to the valve stem with a plastic faced hammer to seat the keys, if necessary.

    Object Number: 64315 Size: SH
  8. Measure the valve spring installed height using a ruler.

    9. Measure from the base of the valve spring to the top of the valve spring.

    Specification

        • If the installed height exceeds 46.25 mm (1.82 in), install a valve spring shim of approximately 0.5 mm (0.02 in) thick.
        • Do not shim the valve spring to obtain less than the specified height.
  9. Install the remaining valves, springs, and other components.

    10. Object Number: 260086 Size: SH
  10. Install sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the coolant temperature sensor.

    11. Notice: Refer to Fastener Notice in the Preface section.

  11. Install the coolant temperature sensor into the left cylinder head.

    12. Tighten
    Tighten the coolant temperature sensor to 20 N·m (15 lb ft).


    Object Number: 260157 Size: SH
  12. Install sealant GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the plug.
  13. Install the coolant plug to the right cylinder head.

    14. Tighten
    Tighten the coolant plug to 20 N·m (15 lb ft).


    Object Number: 1272856 Size: SH
  14. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the sides of the cylinder head core hole plugs (226).
  15. Install the core hole plugs into the cylinder head.

    16. A properly installed plug should be installed 2.5 mm (0.1 in) below the end face of the head.