Tools Required
J 5590 Pinion Bearing Race Installer - Rear
- Install the crankshaft balancer key into the crankshaft keyway.
- Align the keyway of the crankshaft sprocket with the crankshaft balancer key.
- Use the J 5590 in order to install the crankshaft sprocket.
- Rotate the crankshaft until the crankshaft sprocket alignment mark is at the 12 o'clock position.
- Install the camshaft sprocket and the camshaft timing chain.
- Look to ensure that the crankshaft sprocket is aligned at the 12 o'clock position and camshaft sprocket is aligned at the 6 o'clock position.
- Install camshaft sprocket bolts.
- Install the crankshaft position sensor reluctor ring.
The crankshaft balancer key should be parallel to the crankshaft or with a slight incline.
Caution: Wear safety glasses in order to avoid eye damage.
Important: Install the camshaft sprocket with the alignment mark at the 6 o'clock position.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: Do not use a hammer to install the camshaft sprocket onto the camshaft. To do so may dislodge the expansion cup plug, camshaft rear bearing hole.
Tighten
Tighten the camshaft sprocket bolts to 25 N·m (18 lb ft).
| 8.1. | Align the keyway on the crankshaft position sensor reluctor ring with the crankshaft balancer key in the crankshaft. |
| 8.2. | Use the J 5590 in order to push the crankshaft position sensor reluctor ring onto the crankshaft until completely seated against the crankshaft sprocket. |
