Tools Required

J 41712 Oil Pressure Switch Socket

Caution: Wear safety glasses in order to avoid eye damage.

1. Remove the knock sensor retaining bolt (1).
2. Remove the knock sensor (2).



3. Remove the engine oil pressure gage sensor using the J 41712 .



4. Remove the engine oil pressure sensor fitting.



5. Remove the transmission locator dowel straight pins, if required.



6. Remove the engine block left side oil gallery plug.
7. Remove the engine block left rear oil gallery plug.
8. Remove the engine block right rear oil gallery plug.



9. Remove the expansion cup plug from the camshaft rear bearing hole and discard.



10. Remove the expansion cup plug from the balance shaft rear bearing hole and discard.



11. Remove the crankshaft rear oil seal housing locator spring type S pin, if required.



12. Remove the front oil gallery plugs or balls from the front of the engine block and discard.

Insert a 3/8 x 26 inch rod into the rear oil gallery holes in order to drive out the front oil gallery plugs or balls.




13. Remove the engine block core hole plugs.

13.1.

Use a suitable tool in order to drive the engine block core hole plugs into the coolant jacket.

13.2.

Use a suitable tool in order to pull the engine block core hole plugs from the coolant jacket.

13.3.

Discard the engine block core hole plugs.




14. Remove the oil filter bypass valve and discard.