GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The inflatable restraint sensing and diagnostic module (SDM) contains a sensing device that converts vehicle velocity to an electrical signal. The SDM compares this signal to a value stored in memory. When the generated signal exceeds the stored value, the SDM performs additional signal processing and compares the generated signals to values stored in memory. When two of the generated signals exceed the stored values, the SDM will cause current to flow through the inflator modules, deploying the air bags and causing DTC B0051 to set.

This DTC is set when the SDM has commanded an air bag deployment with no faults present.

Conditions for Running the DTC

The SDM must be powered up.

Conditions for Setting the DTC

Ignition 1 voltage must be present and the SDM must have commanded an air bag deployment.

Action Taken When the DTC Sets

    • The SDM commands ON the AIR BAG indicator.
    • The SDM records crash data.

Conditions for Clearing the DTC

DTC B0051 is a latched code. You cannot clear a latched code. Replace the SDM after following the instructions in the following diagnostic table.

Step

Action

Yes

No

1

Did you perform A Diagnostic System Check - SIR?

Go to Step 2

Go to Diagnostic System Check - SIR

2

  1. Turn OFF the ignition.
  2. Inspect the vehicle for signs of air bag deployment.

Does the vehicle exhibit any signs of air bag deployment?

Go to Step 5

Go to Step 3

3

Inspect the vehicle and undercarriage for signs of impact or collision.

Does the vehicle exhibit any signs of impact or collision?

Go to Step 5

Go to Step 4

4

Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .

Did you complete the replacement?

Go to Step 6

--

5

Replace all components and perform inspections as required following an accident. Refer to Repairs and Inspections Required After a Collision .

Did you complete the appropriate inspections and necessary repairs?

Go to Step 6

--

6

  1. Reconnect all SIR system components.
  2. Verify that all components, connectors, and CPAs are properly mounted.

Did you complete the repair?

Go to Diagnostic System Check - SIR

--