For 1990-2009 cars only
- Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
- Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle .
- Remove the wire harness assembly (1) from the wire harness strap (2).
- Remove and dispose of the smaller wire harness straps.
- Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
- Remove the key alarm connector (1) from the electronic lock module assembly (2).
- Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
- Remove the ignition and key alarm switch assembly (1) from the electronic lock module assembly.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
| 6.1. | Rotate the key alarm connector (1) 90 degrees. |
| 6.2. | Pull the key alarm connector (1) out of the electronic lock module assembly (2). |
