Tools Required

1. Lubricate the following parts with synthetic grease:

•	The inner race (1)

•	The lower brass surface of the turn signal cancel cam assembly (4)

2. Install the following parts onto the steering shaft assembly:

2.1.	The inner race (1)

2.2.	The upper bearing inner race seat (2)

2.3.	The upper bearing spring (3)

2.4.	The turn signal cancel cam assembly (4)

2.5.	The shaft lock shield assembly (5)




3. Compress the shaft lock shield assembly (2) using J 23653-SIR and J 42137 .
4. Install the new bearing retainer (1) onto the steering shaft assembly.
5. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
6. Remove J 23653-SIR and J 42137 from the steering shaft assembly.

Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

7. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .
8. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.