Tools Required
J 41396 Park Lock Cable Pliers

1. Install the lock module assembly (1) onto the steering column tilt head assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Screw the 3 pan head tapping screws (2) into the lock module assembly.

Tighten
Tighten the pan head tapping screws to 7 N·m (62 lb in).




3. Install the ignition and key alarm switch assembly (1) onto the lock module assembly (2).
4. Screw the 2 tapping screws into the ignition and key alarm switch assembly (1).

Tighten
Tighten the tapping screws to 1.5 N·m (13 lb in).

5. Install the key alarm connector (3) onto the lock module assembly (2).

4.1.	Push the key alarm connector (1) into the lock module assembly (2).

4.2.	Rotate the key alarm connector 90 degrees so that the key alarm connector locks into place.




6. Connect the park lock cable assembly (1).

•	Place the lock cylinder in the OFF-LOCK position.

•	Place the gear shift lever clevis into the PARK position.

•	Press the locking tab on the end of the park lock cable assembly (1) Into the slot in the lock module assembly.




7. Adjust the park lock cable assembly.

6.1.	Use the shift lever clevis to put the column in the PARK position.

6.2.	Put the ignition switch in the OFF-LOCK position. Remove the key.

6.3.	Unlock the adjuster ring on the park lock cable assembly with J 41396 .

6.4.	Pull on the cable until the park lock latch contacts the shift lever clevis. Release the cable.

6.5.	Securely lock the adjuster ring in place on the park lock cable assembly with J 41396 .

8. Inspect the park lock cable assembly.

7.1.	Put the lock cylinder in the OFF-LOCK position. The shift lever clevis should not shift out of the park position.

7.2.	Turn the key to the run position and put the shift lever clevis in the NEUTRAL position.

7.3.	With the shift lever clevis in the NEUTRAL position the lock cylinder should not go into the OFF-LOCK position.

7.4.	Put the shift lever clevis into the PARK position.

7.5.	Put the lock cylinder in the OFF-LOCK position. Remove the key.

9. Install the upper tilt head components. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .