Removal Procedure
- Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging .
- Remove the radiator grille. Refer to Grille Replacement in Exterior Trim.
- Remove the lower hood latch cover from the vehicle. Refer to Hood Latch Cover Replacement in Body Front End.
- Remove the hood latch from the vehicle. Refer to Hood Primary and Secondary Latch Replacement in Body Front End.
- Remove the left hand headlamp housing. Refer to Headlamp Capsule Replacement in Lighting Systems.
- Remove the A/C lines (4) from the condenser (1).
- Remove the retaining bolts and the condenser (3) from the vehicle.
Installation Procedure
- Install the condenser (3) and the retaining bolts to the vehicle.
- Install the A/C lines (4) to the condenser (1).
- Install the left hand headlamp housing. Refer to Headlamp Capsule Replacement in Lighting Systems.
- Install the hood latch to the vehicle. Refer to Hood Primary and Secondary Latch Replacement in Body Front End.
- Install the lower hood latch cover to the vehicle. Refer to Hood Latch Cover Replacement in Body Front End.
- Install the radiator grille. Refer to Grille Replacement in Exterior Trim.
- Recharge the refrigerant. Refer to Refrigerant Recovery and Recharging .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the condenser retaining bolts to 10 N·m (89 lb in).
Tighten
Tighten the compressor/condenser hose to the condenser to 28 N·m
(21 lb ft).
