GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 323059  Size: SH
  1. Release the barbed tab at the center of the access panel.

  2. Object Number: 323063  Size: SH
  3. Swing the panel down and forward in order to access the module.
  4. Disconnect the electrical connector from the module and switch assembly.

  5. Object Number: 323068  Size: SH
  6. Remove the screws that retain the garage door opener and the switch assembly to the console.
  7. Remove the opener and the switch assembly from the console.

Installation Procedure


    Object Number: 323068  Size: SH
  1. Align the LED indicator with the hole in the access panel when setting the opener into place.
  2. Install the opener and the switch assembly to the console.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the screws that retain the opener and the switch assembly to the console.
  5. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 323063  Size: SH
  6. Connect the electrical connector to the opener and the switch assembly.
  7. Swing the access panel up and rearward in order to close the access panel.

  8. Object Number: 323059  Size: SH
  9. Snap the barbed tab into place in the console.