GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 296157  Size: SH
  1. Loosen the nut on the door jamb switch.
  2. Gently pull the switch away from the body.
  3. Disconnect the door jamb switch from the electrical connector(s).
  4. Tape the wiring to the body in order to prevent the wiring from entering the hole in the door pillar.
  5. Remove the door jamb switch from the vehicle.

Installation Procedure

  1. Install the door jamb switch to the vehicle.

  2. Object Number: 296157  Size: SH
  3. Connect the electrical connector(s) to the door jamb switch.
  4. Notice: Refer to Fastener Notice in the Preface section.

  5. Tighten the nut on the door jamb switch.
  6. Tighten
    Tighten the door jamb switch nut to 3 N·m (27 lb in).