GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2001 🢒 Safari - 4WD 🢒 Transmission/Transaxle 🢒 Shift Lock Control 🢒 Automatic Transmission Shift Lock Control Actuator Replacement

Removal Procedure

    Object Number: 324906 Size: SH

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Remove the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement - On Vehicle in Steering Wheel and Column.
  3. Disconnect the automatic transmission shift lock control actuator electrical connector.
  4. Place the shift lever clevis into the neutral position.
  5. Use a small screwdriver to pry the automatic transmission shift lock control actuator from the steering column jacket assembly.
  6. Remove the automatic transmission shift lock control actuator from the steering column.

Installation Procedure

    Object Number: 324906 Size: SH
  1. Firmly install the automatic transmission shift lock control actuator onto the steering column jacket assembly.
  2. Connect the automatic transmission shift lock control actuator electrical connector.

    3. Object Number: 324912 Size: SH
  3. Adjust the automatic transmission shift lock control actuator (with the shift lever clevis in the neutral position) in the following way:
    4. 3.1. Pull out the tab (1) on the adjuster block side (2) of the automatic transmission shift lock control actuator.
    3.2. Press on the adjuster block (2) to disengage the adjuster teeth. Slide the adjuster block (2) as far away from the actuator as possible.
    3.3. Lock the adjuster block in place by pushing inward on the tab (1).
  4. Inspect the automatic transmission shift lock control actuator for the following items:
    5. 4.1. The automatic transmission shift lock control actuator must lock the shift lever clevis when the shift lever clevis is put into the PARK position.
    4.2. Turn the ignition to the ON position and depress the brake pedal in order to move the gear shift lever out of the PARK position. The actuator will be energized.
    4.3. Readjust the automatic transmission shift lock control actuator if needed.
  5. Install the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement - On Vehicle in Steering Wheel and Column.
  6. Enable the SIR system. Refer to Enabling the SIR System in SIR.