- Inspect the spacer plate
to case gasket for witness marks. The witness marks should be complete. Incomplete
witness marks may come from an uneven case surface or from cross channel leaks.
- Using compressed air,
blow into all of the case fluid passages (3, 7, 8, 11, 16, 18, 26, 29, 37,
45) to ensure that all case fluid passages are clear of any obstruction.
- Inspect the 2-4 servo
bore, the 3rd accumulator retainer and ball assembly (40), the orifice cup
plug (11) in the servo bore, and the 2nd apply piston pin bore for any of
the following conditions:
- Inspect the 3-4 accumulator
bore and the orifice cup plug (38) for any of the following conditions:
- Inspect all bolt holes for thread damage. Use heli-coil to repair
damaged threads.
- Inspect the cooler connectors for damage and proper torque.
Specification
Cooler connector torque should be 38 N·m (28 lb ft)
