GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

J 41712 Oil Pressure Switch Socket.


    Object Number: 348108  Size: SH
  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
  2. Disconnect the engine oil pressure sensor gauge electrical connector.
  3. Hold the engine oil pressure gauge sensor fitting with a wrench.
  4. Remove the engine oil pressure gauge sensor using J 41712 .

  5. Object Number: 348110  Size: SH

    Important: Note the alignment of the engine oil pressure gauge sensor fitting prior to removal.

  6. Remove the engine oil pressure gauge sensor fitting, if necessary.

Installation Procedure

Tools Required

J 41712 Oil Pressure Switch Socket.


    Object Number: 348110  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the engine oil pressure gauge sensor fitting, if removed.
  2. Tighten

    1. Tighten the engine oil pressure gauge sensor fitting to 15 N·m (11 lb ft).
    2. Important: Do not loosen the sensor fitting. Do not tighten the sensor fitting more than one turn.

    3. Tighten the sensor fitting until properly align.

    Object Number: 348108  Size: SH
  3. Install the engine oil pressure gauge sensor.
  4. Hold the engine oil pressure gauge sensor fitting with a wrench to prevent from turning.
  5. Tighten
    Using J 41712 tighten the engine oil pressure gauge sensor to 30  N·m (22 lb ft).

  6. Install the engine oil pressure gauge sensor electrical connector.
  7. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.