Tools Required

J 41352 Steering Column Holding Fixture

1. Install the trim cover protector (1) to the lower trim cover (2).



2. Install the upper trim cover (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the TORX® head screw (1) to the upper trim cover (2).

Tighten
Tighten the screw to 1.5 N·m (13 lb in).





Important: The shift lever seal must seat correctly into the trim covers.

4. Install the lower trim cover (1).
5. Install the 2 pan head tapping screws (2) to the lower trim cover (1).

Tighten
Tighten the screws to 3.5 N·m (31 lb in).





Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

6. Remove the steering column and J 41352 from the vise.
7. Install the steering column into the vehicle. Refer to Steering Column Replacement .
8. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
9. Install the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
10. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.