Caution: Refer to Brake Dust Caution in the Preface section.

Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

1. Remove the brake shoes. Refer to Brake Shoe Replacement .



2. Disconnect the brake pipe.
3. Remove two bolts.
4. Remove the wheel cylinder.

1. Install the wheel cylinder.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolts.

Tighten
Tighten the bolts to 13 N·m (115 lb in).

3. Connect the brake pipe to the wheel cylinder.

Tighten
Tighten the brake pipe fitting to 21 N·m (16 lb ft).

4. Install the brake shoes. Refer to Brake Shoe Replacement .
5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.