GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2002 🢒 Jimmy - 4WD 🢒 Engine 🢒 Engine Controls - 4.3L 🢒 Transfer Case Shift Control Module Replacement

Removal Procedure

    Object Number: 303459 Size: SH
  1. Remove the right lower hinge trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side in Interoir Trim.

    2. Object Number: 662060 Size: SH
  2. Disconnect the 2 wiring harness connectors from the automatic transfer case control module

    3. Object Number: 662055 Size: SH
  3. Remove the 3 nuts securing the automatic transfer case control module to the retainer.
  4. Slide the automatic transfer case control module straight out from the retainer.

Installation Procedure

    Object Number: 662055 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the automatic transfer case control module into the retainer with the 3 nuts.

    2. Tighten
    Tighten the nut to 6 N·m (53 lb in).


    Object Number: 662060 Size: SH
  2. Connect the 2 wiring harness connectors to the automatic transfer case control module.

    3. Object Number: 303459 Size: SH
  3. Install the right lower hinge trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side in Interoir Trim.
  4. Start the engine and test the automatic transfer case system for proper shift operation.