For 1990-2009 cars only
Removal Procedure
- Raise and support the hood.
- Remove the bolt from the right and the left vent grille end panels.
- Lift up on the right and the left vent grille end panels to release the retaining clips.
- Remove the right and the left vent grille end panels.
- Remove the screws that secure the center vent grille panel to the cowl.
- Remove the push-pin retainers that secure the center vent grille panel to the cowl.
- Remove the center vent grille panel from the cowl.
Installation Procedure
- Install the center vent grille panel to the vehicle.
- Install the screws that secure the center vent grille panel to the cowl.
- Install the push-pin retainers securing the center vent grille panel to the cowl.
- Install the right and the left vent grille end panels to the cowl.
- Install the screws securing the securing the right and the left vent grille ends to the cowl.
- Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement in Wipers/Washer Systems.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
