Step | Action | Yes | No | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Fog Lights Schematics Connector End View Reference: Lighting Systems Connector End Views | |||||||||||||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information | ||||||||||||||||
2 | Verify that the front fog lamps are always on. Do the front fog lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 | ||||||||||||||||
3 | Use the scan tool to inspect for the following related Body Control Module (BCM) Data/ Input Parameters and Output Controls. Refer to Scan Tool Data List for typical values and definitions:
Did you find and correct a problem? | Go to Step 13 | Go to Step 4 | ||||||||||||||||
4 | Use the scan tool to monitor the front fog lamp switch input with the switch in the OFF position. Does the scan tool indicate that the switch is ON? | Go to Step 7 | Go to Step 5 | ||||||||||||||||
5 | Remove the front fog lamp relay. Do the front fog lamps turn OFF? | Go to Step 6 | Go to Step 8 | ||||||||||||||||
6 | Using a J 39200 digital multimeter (DMM), check for continuity to ground the front fog lamp relay control circuit at the front fog lamp relay connector in the underhood fuse block. Refer to Electrical Center Identification Views and Circuit Testing in Wiring Systems. Is continuity present? | Go to Step 9 | Go to Step 11 | ||||||||||||||||
7 |
Was a problem found? | Go to Step 10 | Go to Step 12 | ||||||||||||||||
8 | Repair the short to voltage in the front fog lamp supply voltage circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- | ||||||||||||||||
9 | Repair the short to ground in the front fog lamp relay control circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- | ||||||||||||||||
10 | Repair the short to ground in the front fog lamp switch signal circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- | ||||||||||||||||
11 | Replace the front fog lamp relay. Refer to Relay Replacement in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- | ||||||||||||||||
12 | Replace the front fog lamp switch. Refer to Headlamp Switch Replacement Did you complete the repair? | Go to Step 13 | -- | ||||||||||||||||
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 | ||||||||||||||||
