Schematic Reference: Fog Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views or Instrument Panel, Gages, and Console Connector End Views in Instrument Panel, Gages, and Console

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the high beam indicator is inoperative.

Does the high beam indicator operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn the ignition switch to the RUN position.
2. Turn the headlamp switch to the HEAD position.
3. Use the multifunction headlamp dimmer switch to apply the high beams.

Do the headlamps function properly?

Go to Step 4

Go to Symptoms - Lighting Systems

Using a scan tool, select IPC, Special Functions, and command the high beam indicator Lamp ON, then OFF.

Does the lamp turn ON and OFF when commanded?

Go to Step 6

Go to Step 5

1. Inspect for a defective high beam indicator bulb or socket. Refer to Instrument Cluster Bulb Replacement .
2. If the bulb and socket are good, replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.

Did you complete the repair?

Go to Step 7

--

Repair the open or the high resistance in the one of the following components, and refer to Wiring Repairs in Wiring Systems:

Is repair complete?

Go to Step 7

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3