Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery negative cable.
2. Remove the folding outside mirror switch by carefully using a flat-bladed tool in order to pry up on the leading edge.
3. Remove the accessory switch panel from the armrest.

Use a flat-bladed tool in order to carefully pry the cover up at the front leading edge leaving the electrical connections connected.

4. Disconnect the electrical connector from the power folding mirror switch.

1. Connect the electrical connector to the power folding mirror switch.
2. Install the power accessory switch mounting panel to the armrest. Ensure that the retainers lock into place.
3. Install the power folding mirror switch to the door trim panel. Ensure that the retainers lock into place.
4. Connect the battery negative cable.