Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views | |||
1 | Did you review the Exterior Lighting Systems Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Verify that the hazard lamps are inoperative. Do the hazard lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Inspect the HAZ LP fuse in the underhood fuse block. Is the fuse open? | Go to Step 8 | Go to Step 4 |
4 | Using a test lamp from ground, backprobe the battery positive voltage circuit to the multifunction switch at connector C211. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate? | Go to Step 5 | Go to Step 7 |
5 |
Does the test lamp illuminate? | Go to Step 6 | Go to Step 9 |
6 | Test for an open, high resistance or short to ground in the turn/hazard module 2 supply voltage circuit or short to ground in the battery positive voltage circuit. Refer to Circuit Testing in Wiring Systems. Was a problem found? | Go to Step 8 | Go to Step 10 |
7 | Repair the open or high resistance in the battery positive voltage circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 11 | -- |
8 | Repair the open, high resistance or short to ground in the turn/hazard module 2 supply voltage circuit or a short to ground in the battery positive voltage circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 11 | -- |
9 | Replace the multifunction switch. Refer to Turn Signal Multifunction Switch Replacement in Steering Wheel and Column. Did you complete the repair? | Go to Step 11 | -- |
10 | Replace the turn signal lamp flasher. Refer to Hazard and Turn Signal Flasher Replacement . Did you complete the repair? | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
