For 1990-2009 cars only
Removal Procedure
- Disconnect the clutch pedal position switch electrical connector (1).
- Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal.
- If equipped with a NV 3500 or NV 4500 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
- Remove the clutch master cylinder clip from the brake pressure module valve pipe.
- If equipped with a ZF S6-650 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
- Rotate the clutch master cylinder 45 degrees clockwise to the unlocked position.
- If equipped with a NV 3500 or NV 4500 transmission, remove the clutch master cylinder.
- If equipped with a ZF S6-650 transmission, remove the clutch master cylinder.
Installation Procedure
- If equipped with a ZF S6-650 transmission, install the clutch master cylinder.
- If equipped with a NV 3500 or NV 4500 transmission, install the clutch master cylinder.
- Push in and rotate the clutch master cylinder 45 degrees counterclockwise to the locked position.
- If equipped with a ZF S6-650 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
- If equipped with a NV 3500 or NV 4500 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
- Install the clutch master cylinder clip to the brake pressure module valve pipe.
- Apply light pressure to the clutch pedal to couple the pushrod socket to the clutch pedal.
- Connect the clutch pedal position switch electrical connector (1).
- Pump the clutch pedal 3 time prior to starting the vehicle to ensure connection is complete.
