Parking Brake Cable Equalizer Replacement w/Rear Disc

1. Release the park brake.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



3. For the 15 series vehicles, remove the nut from the threaded end of the intermediate cable.
4. Disconnect the equalizer from the rear park brake cables.



5. For 25/35 series vehicles, disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
6. For 25/35 series vehicles, disconnect the cable at the equalizer.

1. For 25/35 series vehicles, connect the cable at the equalizer.



2. For 25/35 series vehicles, enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
3. For the 15 series vehicles, connect the rear park brake cables to the equalizer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




4. For the 15 series vehicles, install the nut to the threaded end of the intermediate cable.

Tighten
Tighten the nut to 3.5 N·m (31 lb in).

5. Remove the safety stands and lower the vehicle.
6. Adjust the park brake system. Refer to Park Brake Adjustment .