GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 GMC Sierra Denali 🢒 Brakes 🢒 Park Brake 🢒 Parking Brake Release Handle Assembly Replacement

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.


    Object Number: 376009 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the park brake release lever mounting bolt.
  3. Remove the park brake release lever handle from the knee bolster.
  4. Remove the MID-bussed electrical center from the bracket.
  5. Remove the park brake release cable housing from the pedal assembly.
  6. Remove the park brake release cable from the pedal assembly.
  7. Note the routing of the cable as you remove the park brake release handle assembly from the vehicle.

Installation Procedure

    Object Number: 376009 Size: SH
  1. Install the park brake release handle assembly to the vehicle. Install the cable using the same routing as the original cable.
  2. Install the park brake release cable to the pedal assembly.
  3. Install the park brake release cable housing to the pedal assembly.
  4. Install the MID-bussed electrical center to the bracket.
  5. Install the park brake release lever handle to the knee bolster.

    6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the park brake release lever handle bolt.

    7. Tighten
    Tighten the bolt to 9 N·m (80 lb in).

  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .