GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 GMC Sierra Denali 🢒 Accessories 🢒 Entertainment 🢒 Radio Volume Compensator Interior Noise Microphone Replacement

Removal Procedure

    Object Number: 1207757 Size: SH
  1. Remove the floor console bezel. Refer to Floor Console Bezel Replacement in Instrument Panel, Gages and Console.
  2. Remove the floor console cupholder. Refer to Cupholder Replacement in Instrument Panel, Gages and Console.
  3. Remove the floor console storage bin. Refer to Front Floor Console Compartment Replacement in Instrument Panel, Gages and Console.
  4. Remove the floor console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages and Console.
  5. Move the drivers seat fully forward.
  6. Reposition the inboard seat track trim (1) in order to gain access to the rear console side panel screw (2).
  7. Remove the rear console side panel screw.

    8. Object Number: 1207752 Size: SH
  8. Move the drivers seat to the fully rearward.
  9. Remove the front console side panel screw (1).

    10. Important: The floor console drivers side trim panel can not be removed until the noise compensation microphone electrical connector hold down clip is released from the console.

  10. Carefully pull outward on the trim panel to release the trim panel clips.

    11. Object Number: 1376879 Size: SH
  11. Release the microphone electrical connector clip from the console.
  12. Disconnect the radio volume compensator microphone (2) electrical connector.
  13. Remove the screws (1) that retaining the radio volume compensator microphone (2) to the floor console trim panel.
  14. Remove the radio volume compensator microphone (2) from the floor console side trim panel.

Installation Procedure

    Object Number: 1376879 Size: SH
  1. Install the radio volume compensator microphone (2) to the floor console side trim panel.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the radio volume compensator microphone screws (1).

    3. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  3. Align the side trim panel to the floor console and connect the radio volume compensator microphone (2) electrical connector.
  4. Install the electrical connector hold down clip to the floor console.
  5. Align the trim panel to the floor console, push the panel towards the floor console to engage the panel clips.

    6. Object Number: 1207752 Size: SH
  6. Install the front console side panel screw (1).

    7. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 1207757 Size: SH
  7. Move the front seat fully forward.
  8. Install the rear console side panel screw (2).

    9. Tighten
    Tighten the retaining screw to 2 N·m (18 lb in).

  9. Reposition the inboard seat track trim (1).
  10. Install the floor console storage bin. Refer to Front Floor Console Compartment Replacement in Instrument Panel, Gages and Console.
  11. Install the floor console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages and Console.
  12. Install the floor console cupholder. Refer to Cupholder Replacement in Instrument Panel, Gages and Console.
  13. Install the floor console bezel. Refer to Floor Console Bezel Replacement in Instrument Panel, Gages and Console.