GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1236369  Size: SH
  1. Drain the cooling system/engine block. Refer to Cooling System Draining and Filling .
  2. Disconnect the knock sensor electrical connector (4).

  3. Object Number: 858224  Size: SH
  4. Remove the knock sensor.

Installation Procedure


    Object Number: 858224  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the knock sensor.
  2. Tighten
    Tighten the sensor to 20 N·m (15 lb ft).


    Object Number: 1236369  Size: SH
  3. Connect the knock sensor electrical connector (4).
  4. Fill the cooling system/engine block. Refer to Cooling System Draining and Filling .