GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1653035  Size: SH
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Using a pick or a small flat-bladed screw driver, remove and discard the quick connect fitting clip from the charged air cooler outlet duct.
  3. Remove the charged air cooler outlet duct from the intake.
  4. Remove the fuel filter. Refer to Fuel Filter Replacement .
  5. Remove the fuel rail pressure sensor. Refer to Fuel Injection Fuel Rail Fuel Pressure Sensor Replacement .

  6. Object Number: 1335614  Size: SH
  7. Prior to removing the fuel injector pipes, use compressed air to blow any debris from between the injector line and fittings. Wipe the fittings clean of debris.
  8. Spray lithium grease, GM P/N 12346293 or equivalent, between the fuel injector line and fittings to assist in containing any debris during removal.
  9. Notice: DO NOT use compressed air to clean debris from the fuel injector inlet after the fuel line is removed. Using compressed air can allow debris to enter the fuel injector inlet and damage the fuel injector.

  10. Remove the fuel injector pipes.

Installation Procedure

Notice: Ensure proper torquing of the fuel injector line. An under-torqued fuel injector line will not seal properly and an over-torqued fuel injector line may damage the fuel injector fitting. An improperly sealed or damaged fuel injector line or fuel injector fitting will cause a fuel leak.

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1335614  Size: SH
  1. Install the fuel injector pipes.
  2. Tighten
    Tighten the fittings to 41 N·m (30 lb ft).

  3. Install the fuel rail pressure sensor. Refer to Fuel Injection Fuel Rail Fuel Pressure Sensor Replacement .
  4. Install the fuel filter. Refer to Fuel Filter Replacement .

  5. Object Number: 1653035  Size: SH
  6. Install a NEW quick connect fitting clip to the charged air cooler duct.
  7. Install the charged air cooler outlet duct to the intake.
  8. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  9. Prime the fuel system. Refer to Fuel System Priming .
  10. Start the engine. If the engine stalls, repeat the above step.
  11. Once the engine starts, inspect for fuel leaks.