Important: Clean all the fuel pipe connections and surrounding areas before disconnecting the pipe in order to avoid possible fuel system contamination.

1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
3. Disconnect the fuel feed chassis pipe from the engine compartment feed pipe (1). Refer to Metal Collar Quick Connect Fitting Service .
4. Cap the fuel pipe in order to prevent possible fuel system contamination.



5. Remove the fuel pipe bracket nuts (510).
6. Remove the fuel pipe bracket (753).
7. Remove the fuel pipe bolt (509).
8. Pull straight up on the pipes in order to remove the pipe (700) from the fuel meter body.



9. Remove and discard the following components from the fuel meter body:

•	Fuel seal retainers (1)

•	Upper fuel seals (2)

•	Spacer rings (3)

•	Lower fuel seals (4)

1. Install the following NEW components to the fuel meter body:

•	Lower fuel seals (4)

•	Spacer rings (3)

•	Upper fuel seals (2)

•	Fuel seal retainers (1)





Caution: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

2. Apply a few drops of clean engine oil to the fuel pipe end.
3. Install the fuel pipes (700) to the fuel meter body.
4. Install the fuel pipe bracket (753).

Notice: Refer to Fastener Notice in the Preface section.

5. Install the fuel pipe bracket nuts (510).
6. Install the fuel pipe bolt (509).

Tighten

1. Tighten the bolt to 6 N·m (53 lb in).
2. Tighten the nuts to 3 N·m (27 lb in).



7. Remove the cap from the fuel pipe.
8. Connect the chassis fuel feed pipe to the engine compartment fuel pipe (1). Refer to Metal Collar Quick Connect Fitting Service .
9. Test the system for leaks using the following procedure:

9.1.	Turn the ignition ON, with the engine OFF for 2 seconds.

9.2.	Turn the ignition OFF for 10 seconds.

9.3.	Turn the ignition ON, with the engine OFF.

9.4.	Inspect for fuel leaks.

10. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .