Notice: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

1. Remove the I/P carrier. Refer to Instrument Panel Carrier Replacement .



2. Disconnect the electrical connector (4) from the right air temperature actuator (3).
3. Remove the screws from the right air temperature actuator (3).
4. Remove the right air temperature actuator (3) from the HVAC module assembly (2).

1. Install the right air temperature actuator (3) from the HVAC module assembly (2).

Notice: Refer to Fastener Notice in the Preface section.

2. Install the screws to the right air temperature actuator (3).

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Connect the electrical connector to the right air temperature actuator.
4. Install the I/P carrier. Refer to Instrument Panel Carrier Replacement .
5. Reprogram the air temperature actuator. Refer to Actuator Recalibration .