GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  3. Object Number: 442292  Size: SH
  4. Remove the knock sensor harness connector.

  5. Object Number: 20272  Size: SH
  6. Remove the knock sensor (2) from the cylinder block (1).

Installation Procedure


    Object Number: 20272  Size: SH

    Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

  1. Install the knock sensor.
  2. Tighten
    Tighten to 19 N·m (14 lb ft).


    Object Number: 442292  Size: SH
  3. Install the knock sensor harness connector.
  4. Lower the vehicle.
  5. Connect the negative battery cable.