Engine Electrical Components P42
Name | Location | Locator View | Connector End View |
|---|---|---|---|
Battery | On the RH frame rail to the rear of the engine | -- | |
Battery Junction Block | On the forward LH side of the bulkhead above P100 | Power and Grounding Component Views in Wiring Systems | -- |
Battery, Secondary (Diesel) | On the RH frame rail to the rear of the engine | -- | |
Clutch Pedal Position (CPP) Switch | On the LH side of the brake pedal bracket | Engine Controls Component Views in Engine Controls | Engine Controls Connector End Views in Engine Controls |
Crank Fuse | On the upper RH side of the steering column support | Power and Grounding Component Views in Wiring Systems | -- |
Generator | At the RH front of the engine | ||
Ignition Switch | On the lower RH side of the steering column below the support bracket | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Instrument Cluster | Body builder installed | -- | Instrument Panel, Gages, and Console Connector End Views in Instrument Panel, Gauges and Console |
IP Fuse Block | Located by the body builder | Electrical Center Identification Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Park/Neutral Position and Backup Lamps Switch | On the LH side of the transmission near the middle | Lighting Systems Component Views in Lighting Systems | Lighting Systems Connector End Views in Lighting Systems |
Starter Motor | At the lower RH side of the engine | -- | |
Starter Relay | On the engine bulkhead relay bracket under the battery junction block | ||
Starter Solenoid | On the starter at the lower RH side of the engine | -- | |
Tachometer (provision for) | Engine harness taped to the ignition coil breakout | -- | -- |
C102 | Engine harness to the generator harness at the RH front of engine below the generator | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C200 | Engine harness to the IP harness, in the bulkhead near P100 | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
G102 (Diesel with Manual Trans) | At the RH front of the engine near the generator bracket | Power and Grounding Component Views in Wiring Systems | -- |
G102 (All Gasoline, Diesel with Auto Trans) | At the rear of the LH cylinder head | Power and Grounding Component Views in Wiring Systems | -- |
G105 | At the rear of the RH cylinder head | Power and Grounding Component Views in Wiring Systems | -- |
G200 | LH interior bulkhead near the relay bracket | -- | -- |
P100 | LH bulkhead left of the steering column | Harness Routing Views in Wiring Systems | -- |
S109 (MFI Diesel) | In the engine harness, approximately 33 cm (13 in) from P100 | -- | -- |
S110 (Gasoline) | In the engine harness, approximately 4 cm (2 in) from the breakout for C200 towards P100 | -- | -- |
S110 (Diesel) | In the engine harness, approximately 4 cm (2 in) from the breakout for the ABS harness connectors C110 and C111 | -- | -- |
S112 (MFI Diesel with Auto Trans) | In the engine harness, approximately 16 cm (6 in) from the starter motor breakout toward P100 | -- | -- |
S112 (MFI Diesel with Manual Trans/EFI Diesel) | In the engine harness, approximately 4 cm (2 in) from the starter motor breakout toward the A/C compressor connectors | -- | -- |
S112 (Gasoline) | In the engine harness, approximately 7 cm (3 in) from the breakout for the ignition control module toward C102 | -- | -- |
S113 | In the engine harness at the starter solenoid interconnect fusible link C3 | -- | -- |
S118 (MFI Diesel) | In the engine harness, approximately 15 cm (6 in) from the glowplug controller breakout towards the generator | -- | -- |
S118 (EFI Diesel) | In the engine harness, approximately 4 cm (2 in) from the starter motor breakout towards the rear chassis connector C300 | -- | -- |
S118 (Gasoline) | In the engine harness at the LH rear of engine, approximately 4 cm (2 in) from G102/G104 breakout toward the bank 1 HO2S | -- | -- |
S128 | In the engine harness at the battery junction block fusible link C2 | -- | -- |
S132 (Gasoline) | In the engine harness, approximately 19 cm (8 in) from the C200 breakout towards the MAF sensor | -- | -- |
S205 | In the IP harness, approximately 4 cm (2 in) before the fuse block breakout toward C200 | -- | -- |
S207 | In the IP harness, approximately 40 cm (16 in) from the fuse block toward the instrument cluster connector | -- | -- |
Engine Electrical Components P32
Name | Location | Locator View | Connector End View |
|---|---|---|---|
Battery (L29) | RH frame rail behind the engine | -- | |
Battery Junction Block | On the forward LH side of the bulkhead | -- | |
Crank Fuse (L29/L65) | In the auxiliary fuse block | -- | |
Generator | On the RH front of the engine | -- | |
IP Fuse Block | Mounted on the IP | -- | |
Ignition Switch | On the steering column | -- | |
Park/Neutral Position (PNP) Switch and Backup Lamps Switch | On the LH side, near the middle of the transmission | -- | |
Secondary Battery (L65) | On the RH side frame rail behind the engine | -- | |
Starter Motor (L29) | On the RH side, rear of the engine | -- | |
Starter Motor (L65) | On the RH side, rear of the engine | -- | |
Starter Relay (L29) | At the relay center on the RH side of the driver's island support | -- | |
Starter Solenoid | At the starter motor | -- | |
C200 | 45 cm from P100, mounted on the driver's island | -- | |
G104 (L29) | 35 cm from the breakout for the ignition coil | -- | -- |
G104 (L65) | 35 cm from the breakout for the ignition coil | -- | -- |
G105 | Negative battery cable | -- | -- |
P100 | Main wiring pass-through at the bulkhead | -- | -- |
S115 (L29/L65) | Engine harness, 34 cm from the breakout for the windshield wiper motor, toward the engine | -- | -- |
S125 (L29) | Engine harness, 5 cm from the breakout for the EGR, toward the injector harness | -- | -- |
S125 (L65) | Engine harness, 9 cm from the breakout for the generator, toward the generator connector | -- | -- |
S135 (L29) | Engine harness, 7 cm from the breakout for the H02 sensors, toward the ignition coil | -- | -- |
S135 (L65) | Engine harness, 7 cm from the breakout for the glowplug controller, toward the glowplugs | -- | -- |
S136 (L29/L65) | Engine harness, 16 cm from the battery junction block stud E | -- | -- |
S154 | IP harness, 12 cm from the breakout for the headlamp switch, toward the fuse panel | -- | -- |
