Tools Required

J 45722 Fuel Sender Lock Ring Wrench

1. Remove the fuel tank. Refer to Fuel Tank Replacement .
2. Disconnect the fuel line from the sending unit. Refer to Plastic Collar Quick Connect Fitting Service .
3. Disconnect the evaporative emission (EVAP) line from the sending unit. Refer to Plastic Collar Quick Connect Fitting Service .

Caution: Drain the fuel from the fuel sender assembly into an approved container in order to reduce the risk of fire and personal injury. Never store the fuel in an open container.

Notice: Avoid damaging the lock ring. Use only J-45722 to prevent damage to the lock ring.

Notice: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the joints.

Important: Do NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.

4. Use the J 45722 and a long breaker-bar in order to unlock the fuel sender lock ring.
5. Remove the sending unit and seal. Discard the seal.
6. Clean the sending unit sealing surfaces.

Turn the fuel sender lock ring in a counterclockwise direction.





Important: Some lock rings were manufactured with "DO NOT REUSE" stamped into them. These lock rings may be reused if they are not damaged or warped.

Important: Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock ring.

Important: Check the lock ring for flatness.

7. Place the lock ring on a flat surface. Measure the clearance between the lock ring and the flat surface using a feeler gage at 7 points.
8. If warpage is less than 0.41 mm (0.016 in), the lock ring does not require replacement.
9. If warpage is greater than 0.41 mm (0.016 in), the lock ring must be replaced.

Caution: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket when reinstalling the fuel sender assembly.

Important: The fuel strainer must be in a horizontal position when installing the sending unit is installed in the tank. When installing the sending unit, assure that the fuel strainer does not block full travel of the float arm.

1. Install the sending unit.

Important: Always replace the fuel sender seal when installing the fuel sender assembly. Replace the lock ring if necessary. DO NOT apply any type of lubrication in the seal groove.

Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.
2. Use the J 45722 in order to install the fuel sender lock ring. Turn the fuel sender lock ring in a clockwise direction.
3. Connect the EVAP line to the sending unit. Refer to Plastic Collar Quick Connect Fitting Service .
4. Connect the fuel line to the sending unit. Refer to Plastic Collar Quick Connect Fitting Service .
5. Install the fuel tank. Refer to Fuel Tank Replacement .