GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 813243  Size: SH
  1. Loosen the outlet duct clamp at the upper intake manifold cover.
  2. Remove the upper intake manifold cover from the outlet duct.
  3. Remove the upper intake manifold cover.

  4. Object Number: 813244  Size: SH
  5. Loosen the outlet duct clamps at the turbocharger and the mass air flow/intake air temperature (MAF/IAT) sensor.
  6. Remove the outlet duct from the turbocharger and MAT/IAT sensor.

Installation Procedure


    Object Number: 813246  Size: SH

    Important: The outlet duct must be fully seated against the positive stop feature on the turbocharger inlet.

  1. Install the outlet duct to the turbocharger.
  2. Align the outlet duct alignment indicator (1) to the turbocharger alignment indicator (2).

  3. Object Number: 813244  Size: SH

    Important: The outlet duct must be fully seated against the MAT/IAT sensor with the edge of the seal in the vertical position.

  4. Install the outlet duct to the MAT/IAT sensor.
  5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Tighten the outlet duct clamps at the turbocharger and the MAF/IAT sensor.
  7. Tighten
    Tighten the clamp to 6 N·m (53 lb in).


    Object Number: 813243  Size: SH
  8. Install the upper intake manifold cover.
  9. Install the upper intake manifold cover to the outlet duct.
  10. Tighten the outlet duct clamp at the upper intake manifold cover.
  11. Tighten
    Tighten the clamp to 6 N·m (53 lb in).