Important: Use care when handling the mass air flow/intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage the honeycell located at the air inlet end of the sensor. Do not touch the sensing elements or allow anything including cleaning solvents and/or lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation. Do not drop or roughly handle the MAF/IAT sensor.

1. Remove air outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
2. Lift up the gray retainer, until a click is heard.
3. Disconnect the sensor electrical connector (4).
4. Loosen the clamp securing the sensor.
5. Remove the sensor.

Important:: The arrow on the sensor indicates the proper air flow direction. The arrow must point toward the engine.

1. Locate the arrow (2) on the sensor.



2. Install the sensor.
3. Tighten the clamp securing the sensor.
4. Connect the sensor electrical connector (4).
5. Push down the gray retainer, until a click is heard.
6. Install air outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .