Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Remove the negative battery cables.



2. Remove the sensor electrical connector.
3. Remove power steering pump. Refer to Power Steering Pump Replacement in Power Steering System.



4. Remove the sensor mounting bolt.



5. Remove the sensor from engine.

Important: Care must be taken when handling the sensor. Damage to the sensor will affect proper operation of the injection timing control system.

6. Inspect the sensor O-ring for wear, cracks or leakage and replace if necessary.

1. Lube the new O-ring with engine oil.
2. Install the sensor in the engine.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the sensor mounting bolt.

Tighten
Tighten the mounting bolt to 25 N·m (18 lb ft).




4. Install the sensor electrical connector.
5. Install the power steering pump. Refer to Power Steering Pump Replacement in Power Steering System.
6. Install the negative battery cables.

Important: A new TDC Offset must be learned after replacing a crankshaft position sensor. Refer to Fuel Injection Pump Top Dead Center Offset Adjustment .